그림을 클릭하면 큰 그림을 보실 수 있습니다.
MEX-PKL

MEX-PKL is adequately designed for the sites where the plume or water dispersion is seriously claimed such as resident areas, commercial areas or hospitals.

 

High efficient Infill
   Nozzle sprayed water tend to flow inwardly by the airflow and the bottom corners become a dead areas of heat transfer. Our newly designed fill and its pitch arrangement technology minimize this drag and so increase the total thermal performance.
Dual water distribution System
   In addition to spray nozzle, another water dispersion system installed in between nozzle and fill banks
WIDE AIR TRAVEL
   Maximize the fill width for tower size.
The optimum design of air fluid.
  Remove DEAD AREA of air fluid, and raise efficiency by the optimum contrariety of FAN and FILL.
High efficient fan
   High efficiency aluminum fan blades-pultruded and hollow inside
The others
  Adopt FAN CYLINDER formal PRESSURE RECOVERY FLARE.
Why is the plume generated from cooling tower?

1. As the air flowed in by fans contacts with the hot water, it becomes hot and saturated. Meanwhile the hot water transfer its heat to air and getting cold.

2. When the saturated hot air is discharged from tower, it immediately contacts with cold air outside and part of the vaporized water contained will become a small visible droplets, the plume
Schematic View
그림을 클릭하면 큰 그림을 보실 수 있습니다.
How we reduce the plume?
The most popular measures is to heat the fully saturated air just before it is discharged out from tower so as to drop it's saturation ratio to about 70.80 percent. As this heated air is not fully saturated, there's still rooms to keep the vapor in gas, no visible droplets.